One cable slipping off its drum groove is enough to jam a door mid-cycle or send a panel crashing at an angle. We fix the cable and check why it slipped in the first place.
When one lift cable fails, the other has seen the same wear cycle. We replace both to prevent a repeat call.
Frayed cables often trace back to worn or damaged drum grooves, so we inspect the drums every time, not just the cable.
Our technicians are trained to safely release and reset tension when cables are involved, not just the springs.
We carry the common cable lengths and gauges for most residential door sizes.
Each service below is handled by a technician trained specifically for this kind of repair, not a generalist guessing at it.
A snapped cable leaves the door hanging unevenly on the remaining side, an unsafe condition we treat as priority.
Catching a fraying cable early avoids the sudden, uneven drop that comes with a full snap.
A cable that's jumped its drum groove can jam the door mid-cycle. We reset it correctly and check for the underlying cause.
We match new drums to the correct diameter for your door's cable length requirements.
Correcting an uneven lean means addressing the cable, checking the spring pair, and confirming the track is still square.
Tell us if the door is hanging crooked or jammed, that detail helps us prioritize the call correctly.
Technicians carry standard cable gauges and lengths for most residential doors.
We check both cables and the drums together, then quote a flat price covering the full fix.
Cables replaced, tension balanced, and the door tested level before we leave, backed by written warranty.
“Cable kept jumping the drum every few cycles. Turned out the drum itself was cracked, replaced and fixed.”
“Caught the fraying cable during a routine call before it actually snapped. Appreciated the heads-up.”
“Same-day fix on a Saturday, cable stock right there on the truck.”
This almost always means one lift cable or spring has failed while the other side is still holding weight.
We recommend replacing both since they wear on the same cycle, and we'll explain the reasoning before you decide.
This is a genuine safety hazard, especially with people or vehicles near the door opening.
Usually a bent or worn drum groove, sometimes combined with a slightly loose cable tension setting.
You'll get a confirmed price on-site once the technician inspects the full cable and drum setup.
A snapped-cable call usually resolves in under two hours on-site.
Same-day dispatch, upfront pricing, and a written warranty on every visit.
☎ Call +1-831-293-1591From one side of Overland Park to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Overland Park, KS